instructions for
Motorcycle brake piston reMoval kit-
14pc
model no:
Ms162
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
WarninG!
Wear appropriate Personal Protective equipment. A full range of Personal Protective equipment is available from your
sealey dealer.
WarninG!
ensure that Health & safety, local Authority regulations and general workshop practice regulations are adhered to when
using tools.
8
Do not
use tools if damaged.
9
maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
9
ensure that a vehicle that has been raised by a jack is adequately supported.
9
Wear suitable clothing to avoid snagging.
8
Do not
wear jewellery. tie back long hair.
9
Account for all tools, parts and components being used.
8
Do not
leave tools in or near the engine. return tools to suitable storage after use.
9
When not in use, store in a safe dry and childproof place.
9
Keep children and unauthorised persons away from the work area.
2. introDuction
extract brake calliper pistons without risk of damage to outer face of piston. fast and simple operation. features detachable slide hammer for
impact removal. the kit includes 12 adaptors to suit different sized pistons.
3. specification
model no .....................................................................ms162
capacity ............................................................... Ø19-30mm
4. operation
4.1.
Select correct size adaptor for the job requirements. (fig.1.1).
4.2.
Clamp brake calibre in soft jaw vice (fig.2).
4.3.
Remove inner spindle by unscrewing from main body of tool (fig.1.2). Slide adaptor on to spindle slotted end first, reassemble
tool.
4.4.
slide adaptor into Brake piston and tighten to clamp the adaptor inside the piston.
4.5.
Screw slide hammer to end of tool (fig 2).
4.6.
With care use the slide hammer for impact removal to pull the piston from the housing (fig 3).
4.7.
remove tool from piston in reverse order to above.
ms162 | issue 1 17/05/16
Original Language Version
© Jack sealey limited
Wear
Protective
Gloves
refer to
instruction
manual
Wear eye
Protection
2
3
1
Fig 1.
