Ø12-38MM WHEEL BEARING PULLER 3 JAW
MODEL NO:
MS0621
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
WARNING!
Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
9
This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer’s manual.
9
Ensure that the kit is correct for the task.
9
Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey stockist.
8
DO NOT
use the kit for any purpose other than that for which it is designed.
9
Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9
Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey stockist.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
DO NOT
use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
9
After use, store in a safe, dry childproof area.
2. INTRODUCTION
3-Jaw design applies even pressure preventing damage to bearings. Designed to remove bearings with Ø12-38mm internal diameter. Forged
and heat treated steel jaws for greater strength. Corrosion resistant black oxide finish.
3. CONTENTS
fig.1
MS0621 Issue 1 02/11/2020
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
