INSTRUCTIONS FOR:
RECHARGEABLE
FLUORESCENT
LANTERN
MOdel No.
ML111.V2
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product
will, if used according to these instructions and properly maintained, give you years of
trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE
THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE
FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
NOTE: It is our policy to continually improve products and as such we reserve
the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this equipment.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will
be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on
01284 757525 and leave your full name and address, including postcode.
1.1. GENERAL SAFETY
WARNING!
ensure the lantern is correctly charged before initial use.
DO NOT
allow children to use the lantern.
DO NOT
use if the battery or the lantern casing is damaged.
Only use the supplied battery and charger with this lantern.
When not in use store the lantern in a safe, dry, childproof
location.
1.2. BATTERY SAFETY INSTRUCTIONS
WARNING!
Powered by a sealed lead-acid battery which can be
dangerous if not handled with care.
Charge battery prior to first use. The battery will have been shipped
in a low charge state. Minimum initial charge time 16 hours.
Use only the charger provided to charge the battery.
DO NOT
charge battery when room temperature is below 50°F
(10°C) or above 104°F (40°C).
DO NOT
attempt to recharge the battery by means of an engine
generator or a dC power source.
DO NOT
short-circuit the battery by linking both terminals with a
metal object, or your fingers etc.
DO NOT
store the battery (or lantern) in locations where the
temperature may exceed 104°F (40°C) such as outside sheds,
above heaters, or metal buildings in summer.
WARNING! Dispose of spent battery correctly and in accordance
with local regulations as it contains acid.
DANGER! DO NOT attempt to dismantle the battery.
For safety and environmental reasons DO NOT discard in domestic
waste or by burning. ONLY discard or recycle according to local
waste authority regulations.
WARNING! DO NOT allow a leaking battery to come into contact
with your skin. If you come into contact with battery fluid take
immediate action:
a) Skin contact: Wash immediately with soap and water.
b) Eye contact: Flush eye immediately with cool, clean running
water for at least 15 minutes and seek immediate professional
medical attention.
1.3. ELECTRICAL MAINS POWER SAFETY
ONLY USE THE SUPPLIED CHARGER PLUG (fig 2) FOR
CONNECTING UNIT TO THE MAINS` ELECTRICAL POWER SUPPLY.
WARNING!
It is the user’s responsibility to read, understand and
comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the
installation of appropriate safety devices. An RCCB (Residual Current
Sole UK Distributor,
Sealey Group,
Bury St. edmunds, Suffolk.
01284 757500
01284 703534
www.sealey.co.uk
Web
ENVIRONMENTAL PROTECTION.
Recycle unwanted materials instead of disposing of
them as waste. All tools, accessories and packaging
should be sorted, taken to a recycle centre and
disposed of in a manner which is compatible with the
environment.
When the product is no longer required, it must be
disposed of in an environmentally protective
way.
BATTERY DISPOSAL.
See section 4.3
Fig.5
4.2.
Replacing the fluorescent bulb.
The 12W spiral fluorescent bulb
should be replaced with one of the exact type and specification as
that supplied with the lantern. Contact your Sealey dealer for a
replacement.
Part No. ML111/SB
4.2.1. To access the bulb rotate the top of the lantern anticlockwise until the
mark on the lid lines up with the 'OPeN' mark on the upper part of
the lantern just above the shroud and lift off the top with bulb
attached.
4.2.2 ease the old bulb out of it's plastic clip on the underside of the lid
and insert a new bulb ensuring that it is fully seated under the plastic
clips.
4.2.3 lower the bulb through the hole in the top of the lantern. Align the
mark on the lid with the 'OPeN' mark on the upper part of the lantern
and rotate the lid clockwise for about 30° until it stops.
4.3.
Battery removal and disposal.
4.3.1
Invert the lantern and unscrew the base cover to reveal the battery.
lay the lantern on its side and slide out the battery and stand it
vertically to access the terminals. Pull the connectors from the
terminals and remove the battery.
4.3.2 dispose of the battery according to local authority regulations
specified for lead acid batteries.
Original Language Version
Ml111.V2 Issue: 2 - 02/11/09
Original Language Version
Ml111.V2 Issue: 2 - 02/11/09
Original Language Version
Ml111.V2 Issue: 2 - 02/11/09
