background image

STEERING TURNTABLES - PAIR

MODEL NO: 

GA44.V3

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, 

and properly maintained, give you years of trouble free performance.

IMPORTANT:

 PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE 

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1.  SAFETY

 

 

‰

   WARNING!

 

Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.

 

9

   Maintain  the

 

turntables in good condition (use an authorised service agent).

 

9

   Replace or repair damaged parts. 

Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

 

9

 Locate 

turntables in a suitable working area, keep area clean and tidy and free from unrelated materials. 

 

‰

   WARNING! 

Use turntables on level and solid ground.

 

9

   Keep the turntables clean to ensure accurate performance.

 

8

   DO NOT

 use outside in damp or wet weather conditions. 

 

8

   DO NOT

 allow untrained persons to operate the turntables.

 

8

   DO NOT

 leave a vehicle unattended on the turntables.

 

‰

   WARNING! 

When setting front end alignment on commercial vehicles never make adjustments to drop arms or interconnecting links.  

  Doing so could result in serious tyre, wheel and steering problems.

 

9

   Any alignment changes deemed necessary as a result of using this equipment must be made strictly in accordance with the vehicle   

  manufacturer’s recommendations.

2.  INTRODUCTION

Use in conjunction with Model No. GA42 Gauge Set for accurate castor and kingpin alignment. Also measures toe-in/out and full lock angles. 

Locking pins prevent rotation of table whilst driving vehicle on and ensure accurate angular measurements. Measures up to 55º rotation in either 

direction. Maximum loading 4000kg per pair.

3.  SPECIFICATION

Model no ..................................................................GA44.V3

Capacity ..........................................4tonne pair, 2tonne each

Range .............................................................................±55°

Table diameter ........................................................... 400mm

Table height ................................................................. 50mm

Table movement ........62mm front to back, 55mm side to side

4.  PREPARATION AND USE

4.1. 

  

Before use, lock the sliding action of each turntable by inserting the locking pins. 

4.2. 

  

The turntables must be placed on a dry, non-slip surface to prevent them moving when the vehicle is driven onto them. Place a  

 

 

turntable in front of each wheel with the turntable itself centred on the tyre and the scale facing outwards to the left or right.  

 

 

Ensure that the two turntables are in line with each other and parallel to the front of the vehicle. With the locking pins still in position,   

 

drive the vehicle onto the turntables until the centres of the wheels are positioned over the centres of the respective turntables as    

 

shown below. The process will be easier if a second person is available to give guidance. Switch off the engine and engage the  

 

 

handbrake. Remove the locking pins from each turntable.

Refer to 

instruction

manual

Original Language Version

© Jack Sealey Limited

GA44.V3 | Issue:1  26/02/20

Отзывы: