1. SAFETY
9
Only use on firm, level, unobstructed surfaces which are capable of supporting the stand and drill.
9
Ensure stand is fixed to surface capable of supporting stand, drill and work piece.
9
Replace or repair damaged parts. Use only recommended parts. Unauthorised parts may be dangerous and will invalidate the
warranty.
WARNING!
Failure to comply with these instructions may result in damage to the stand or other property and/or personal injury.
WARNING!
The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this product,
but must be applied by the operator
2. INTRODUCTION
L
ightweight aluminium diamond core drill stand features tilting mechanism and base plate with anchor fitting. Handle and wheels for ease of
transport. Ideal for use with Model No’s DCD110V and DCD230V Diamond Core Drills.
3. SPECIFICATION
Maximum Drill Bit Diameter: .................................... Ø200mm
T
ravel Length: ............................................................ 600mm
4. OPERATION
4.1.
ATTACHING DRILL TO STAND REF. FIG 1
4.1.1.
The drill is attached to the stand using the drill clamp (fig.1)
4.1.2.
Remove one half of the drill clamp by means of the screws, slot the drill into place and replace the clamp.
4.1.3.
Secure the clamp by using the two locking handles.
4.2.
SECURING STAND TO THE GROUND
4.2.1.
To bolt the stand to the ground, drill a hole for a securing bolt a suitable distance away from your intended drilling area.
Note:
You do have some adjustment on the drill base but plan before you drill.
4.2.2.
The base can be levelled using the 4 levelling bolts. Adjust these before securing the anchor bolt.
4.3.
SETTING THE ANGLE
4.3.1.
Loosen the angle adjustment bolt and the brace locking handle, slide up or down until you get the desired angle.
fig.1
DIAMOND CORE DRILLS STAND
MODEL NO:
DCDST
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear ear
protection
Wear safety
footwear
Wear protective
clothing
Wear a mask
DCDST Issue 3 (2) 26/08/2020
