INSTRUCTIONS FOR
VEHICLE STORAGE SHELTER (2.7 X 5.5 X 2MTRS)
MODEL NO:
CCS01
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
NOTE:
This is a temporary structure and is not recommended as a permanent structure.
9
Choose your shelter’s location carefully. Check for overhead utility lines, branches, etc.
DO NOT
install near roofs or other structures that
may shed snow, ice or excessive run-off onto your shelter. Keep away from electrical wires!
9
Have an overview of all parts before attempting installation. Make sure all components are available.
8
DO NOT
use this product in environments for which it is not intended (i.e. extreme cold, high winds, extreme heat, heavy rainfall, etc).
9
Always wear safety glasses when assembling this product. Wear gloves when working with tubing to prevent cuts or abrasions.
WARNING!
Anchors must be used with alI shelters. Covers should
NOT
be installed untiI it has been properly anchored to the ground.
NOTE:
Proper anchoring and keeping cover tight and free of snow and debris, is the responsibility of the consumer. Damages caused
by improper anchoring are not covered under warranty.
WARNING!
Keep all flame and heat sources away from the shelter fabric. The fabric will burn if left in continuous contact with a flame
source.
8
DO NOT
use open flames or cooking or heating devices inside or in close proximity to the product, including all types of stoves, gas
heaters, gas lanterns, citronella torches, mosquito coils, etc.
WARNING!
In order to reduce risk of burning and avoid damage,
DO NOT:
- cook, smoke, refuel or use any open flame devices in or around the shelter.
- store flammable liquids (gasoline, kerosene, propane, etc.) in the shelter.
- operate gas powered equipment in or around the shelter.
WARNING!
Keep open flames a safe distance away from the shelter.
8
DO NOT
use hard-edged tools or instruments, such as rakes or shovels, to remove snow. These can cause punctures to the cover.
▲
NEVER
start the engine of any vehicle or machine inside a closed shelter. Ensure that there is adequate ventilation for starting
engines and for any work with paints, cleaners, etc.
8
DO NOT
use bleach, alkaline or harsh detergents for cleaning. Doing so will damage the polycarbonate material. Soap and warm
water are recommended.
9
This temporary shelter is intended to offer protection from damages caused by the sun, light rain, light snow, tree sap, bird and animal
excrements.
DO NOT
use it to shield goods from high winds, heavy snow or ice storms. Only use it for its intended purpose.
2.
i
INTRODUCTION
Made from durable anti-scratch material to protect vehicle’s paintwork. Rigid tubular frame with hinged opening for easy access.
Hook and loop vents allow increased ventilation while still keeping vehicle protected from elements. Includes anchor points for fixing
shelter to driveway/ground (fixings not included). Padlock hasp and additional ground anchor point for increased security when canopy is
closed.
3.
i
SPECIFICATION
Model No: ...................................................................CCS01
Dimensions (W x D x H) ..............................2.7 x 5.5 x 2 mtrs
4. ASSEMBLY
4.1.
ASSEMBLY PREPARATION
4.1.1.
Place all parts from the packaging box in a cleared area and arrange them on the ground in front of you.
4.1.2.
Remove all packaging materials and place them back in the box.
DO NOT
dispose of the packaging materials until assembly is
complete.
4.1.3.
Check for completeness of components and transport damages.
WARNING! DO NOT
place the product under trees from which hard fruit such as apples, walnuts or heavy pine cones, etc., may fall.
4.1.4.
Keep children away during assembly. This product contains small parts which can be swallowed by children.
8
DO NOT
attempt to assemble the product if any parts are missing.
4.1.5.
At least 2 people are needed to complete the assembly as some of the steps require awkward lifting and fitting.
WARNING! DO NOT
leave the shelter unattended during assembly. Otherwise, personal injury or damage to the shelter may occur.
CCS01 Issue 1 13/04/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear protective
gloves
Wear eye
protection
