instructions for
Mobile tool & parts trolley
model no:
ap705M series
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
WarNiNG!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this trolley.
WarNiNG!
be careful to ensure that when closing the sliding top you do not catch any part of your body between the runners.
9
Always load evenly with the centre of gravity of the load as near centre of the trolley as possible.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the trolley clean and tidy in accordance with good workshop practice.
9
use the wheel locks to prevent the trolley from inadvertently moving.
9
Keep children and unauthorised persons away from the work area.
8
Do Not
overload the trolley.
max capacity 100kg.
8
Do Not
use the trolley
for any purpose other than that for which it is designed.
8
Do Not
stand on the trolley, use it as a ladder or allow others to ride on the trolley.
8
Do Not
leave unattended, especially when loaded, unless the wheels are locked, chocked or the trolley is otherwise secured.
8
Do Not
use trolley on uneven ground and do not run over curbs or steps - use a ramp.
8
Do Not
use trolley if any part is significantly damaged, paying particular attention to the wheels.
8
Do Not
move trolley with draws out ensure they are closed and locked.
8
Do Not
pull out more than one loaded drawer at any one time or tipping may occur.
8
Do Not
overload drawers.
8
castors limited to 2.5 mph travelling speed.
8
Do Not
tow unit.
Note! Do not force side drawers open, they will open only when the sliding top is open.
Note! The assembly will require assistance.
2.
iNtroDuctioN
Heavy gauge steel construction with lockable sliding top on smooth ball bearing runners. twin drawers with 35mm heavy-duty ball bearing
slides, which are locked when top is closed. Side handle for comfort and control when manoeuvring. Fitted with four wheels, two fixed and two
locking castors. suitable for tools and parts. some self-assembly required.
3. specificatioN
model no: ......................................AP705m.V2/AP705mB.V2
size (W x d x H):.....................................770 x 370 x 830mm
load capacity: .............................................................. 100kg
4. parts
AP705m.V2, AP705mB.V2| issue 1 06/04/16
Original Language Version
© Jack sealey limited
refer to
instructions
Warning:
Beware
crushing of
hands.
unit may tip.
close and lock
drawers before
moving.
use one drawer
at a time.
serious injury
may occur.
Do Not
pull
unit.
Push to move.
Do Not
tow.
caution:
remove items
from work
surface prior
to closing lid.
failure to do
so will result in
damage to lid.
Hang on cabinets:
caution. make sure
cabinet is weighted
down enough to counter
balance the weight of
any side hanging unit.
make sure cabinet will
not tip over if any loaded
draw is extended.
Do Not
attempt to lift
cabinet using the lids
when loaded, only lift
this way when empty.
Before pulling out any
loaded drawer, make
sure unit is weighed
down enough to avoid
tipping.
