INSTRUCTIONS FOR:
TRADE COMBINATION LADDERS
3-SECTION
Model No's:
ACL3.V3, ACL307, ACL312.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
1. SAFETY / uSAgE INSTRuCTIONS
IMPORTANT:
PLEASE READ THESE INSTRuCTIONS CAREFuLLY. NOTE THE SAFE OPERATIONAL REQuIREMENTS, WARNINgS & CAuTIONS.
uSE THE PRODuCT CORRECTLY AND WITH CARE FOR THE PuRPOSE FOR WHICH IT IS INTENDED. FAILuRE TO DO SO MAY CAuSE
DAMAgE OR PERSONAL INJuRY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRuCTIONS SAFE FOR FuTuRE uSE.
2. INTRODuCTION
2.1
Introduction
Multi-use aluminium extension ladders manufactured to EN131 standards. Ideal for the tradesman, these ladders can be used as a
3-section or 2-section extension and as a single ladder, which is ideal for two-man use. Can be used as a step and extension step
ladder where stability and height are needed. Compact size for easy handling and storage. Two larger models suitable to extend up to
the apex of a house.
Before use:
a) Check your physical fitness before using a ladder.
Certain pathologies or medicines, overindulgence in alcohol or
consumption of drugs can represent a danger.
b) When transporting a ladder on the roof rack of your vehicle or
in a lorry, make sure that it is secured firmly to avoid causing any
damage.
c) Before using the ladder for the first time, check it to ensure
that all its parts are in good condition and operate correctly.
d) Before use, check the ladder visually to ensure that it has not
been damaged and can be used in complete safety.
e) Regular checks are essential for all users.
f)
Check that the ladder is suitable for the job to be done.
g) Do not use a damaged ladder.
h) Clean the ladder of any foreign substances such as wet paint,
mud, oil or snow.
i)
Before using the ladder for professional purposes, risks must
be assessed depending on the legislation of the country in use.
Positioning and Erecting Ladders:
a) Ladders must be put up in the right position, i.e. at the correct
angle (inclined at about 1 in 4), with the steps or rungs parallel
for a leaning ladder, or completely open in the case of a trestle
ladder.
b) Any ladder equipped with locking systems; the locks must be in
the fully locked position.
c) Ladders must be placed on flat regular and firm surface.
d) Leaning ladders must always be placed on a flat solid surface
and be stabilized before use, for example by using ties or any
other suitable device for ensuring their stability.
e) Ladders must never be repositioned from a point high-up.
f)
When installing a ladder take account of any possible risks of
collision, e.g. collisions with pedestrians, vehicles or doors.
If possible, secure any doors (other than emergency exits) and
windows on the site.
g) Identify all electrical risks on the work-site, e.g. overhead lines or
any other bare electrical equipment.
h) Ladders must rest firmly on their treads and not be on rungs or
steps.
i)
Ladders must not be placed on any slippery surfaces (e.g. ice,
shiny surfaces or surfaces clearly covered with foreign
substances) unless other effective means have been taken to
avoid the ladder slipping. Otherwise, make sure that all dirty or
contaminated support surfaces have been adequately cleaned.
Using the Ladder:
a) Do not exceed the maximum load allowed for the type of ladder.
b) Do not try to reach a point too far away from you; your waist
should always be between the ladder’s two uprights and your
feet on the same step or rung whilst working.
c) Do not climb down a high leaning ladder without using an extra
safety system (for example, a tie or use of a suitable stabilizing
device).
d) Do not use a trestle ladder to get up to a higher level.
e) Do not stand on the top three steps or rungs of a leaning ladder.
f)
Do not stand on the top two steps or rungs of a trestle ladder
where there is no platform or support at hand or knee height.
g) Do not stand on the top four steps or rungs of a trestle ladder
with an extension ladder on top.
h) Ladders should only be used for minor, short-duration jobs.
i)
Use non-conductive ladders when working on jobs where
electrical power is present.
j)
Do not use ladders outside in unfavorable weather conditions
(high winds for example).
k) Take all necessary precautions to prevent children from playing
on ladders.
l)
If possible, secure any doors other than emergency exits and
windows on the site.
m) Climb up and come down a ladder facing it.
n) Hold the ladder firmly when climbing or coming down.
o) Do not use ladders as bridges.
p) Always wear suitable shoes for climbing ladders.
q) Avoid all excessive lateral constraints such as when using
a drill in brick and concrete.
r) Do not stay too long up the ladder without making regular
stops (fatigue risks).
s) To go up to higher levels, ladders should be extended at
least one metre above the height to be reached.
t)
Light-weight easy-to-handle equipment should be used
when on a ladder.
u) Avoid works that create side loads on trestle ladders, e.g.
for drilling hard materials (brick, concrete, etc.).
v) Hold onto the ladder with one hand when working. If this
is not possible, other types of safety measures should be
taken.
Repairs and maintenance must be carried out by a
qualified person in compliance with the manufacturer’s
instructions. Ladders should be stored according to the
manufacturer’s instructions.
Model No:
ACL307
ACL3.V3
ACL312.V2
Minimum Height:
1.99mtr
2.55mtr
3.39mtr
Maximum Extension:
4.23mtr
5.91mtr
7.31mtr
Maximum Reach:
5.13mtr
6.81mtr
8.21mtr
Maximum Capacity:
150kg
150kg
150kg
Weight:
9.1kg
12.5kg
17.3kg
ACL3.V3, ACL307, ACL312.V2 Issue: 1 - 19/12/11
