6-24V AUTO PROBE PLUS
MODEL NO:
PPX.V4
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
8
DO NOT
use the unit around explosive gas, vapor, or dust.
8
When the rock switch is pressed (or rocked), battery current is conducted directly to the tip which may cause sparks when
contacting ground or certain circuits.
8
The unit is not to be used with 110/220-volt domestic mains supply, it is only for use with DC 6 - 24V systems.
8
DO NOT
use on AC voltage.
9
After working on a vehicle, correctly restore all the connections which were disconnected.
9
Always follow the instructions and procedures indicated in the manufacturer’s service manual before attempting to disconnect any
part or subsystem of the electrical circuit.
9
Use caution when using the unit to perform measurement. Never touch any dangerous part of the vehicle, for safety.
8
DO NOT
touch any live conductor with hand or skin.
8
DO NOT
use probe if it is damaged.
9
Some components of vehicle work on lower voltage, they can not withstand the voltage applied by the unit. To avoid damage to
these components, don’t use the unit to apply voltage to them directly or indirectly.
9
Before driving vehicle, always make sure that the vehicle is safe and reliable.
8
DO NOT
use the unit if the vehicle is being driven.
2. INTRODUCTION
6-24V Auto Probe with an integral work light to aid use in dark engine bays plus an audible circuit tester for when the LED on the probe cannot
be seen.
3. FEATURES
1
Red battery clip
2
Black battery clip
3 Probe
4
Work lights
5
‘Touch contact’ to turn on the lights
6
Test indicator
7
Rock switch
It includes a front part “ - “, and a rear part “= “.
When pressed the front part” - “, the probe is connected to
the red battery clip directly.
When you press the rear part”=”, the probe is connected to
the black battery clip directly.
8
Auxiliary ground lead
4. OPERATION
4.1.
CONNECTION
4.1.1.
Unroll the unit’s cable. Clamp the red battery clip to the positive
terminal of the vehicle’s battery.
4.1.2.
Clamp the black battery clip to the negative terminal of the
vehicle’s
battery.
4.1.3.
The unit starts self-test, the built-in buzzer sounds,
the test indicator’s green light, red light and the
work lights light in turn.
4.1.4.
Several seconds later, the self-test finishes.
Note: The buzzer sounds continuously and then sounds intermittently.
PPX.V4 Issue 1 06/06/22
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
