Sealed Air SeleCTech, Руководство пользователя

Страница: 44 / 64

Section 4. Maintenance & Troubleshooting
SLCT-FAL5645 Sealing Machine
© Sealed Air Corporation (US)
MM-0110; Revision 1-A: 11/01/2013 4-9
Item Problem Possible Causes Recommended Action
10
Warning Buzzer of the
sealing process is “ON”
The micro-switch of the sealing
process is blocked Reposition the micro-
switch
Product is pressed by the
sealing blade Press the Manual sealing
operation switch to remove
the pressed product
The machine stop when the
sealing blade presses down and
the buzzer is “ON” Lower the actuator or
adjust the magnetic spring
switch of the cylinder
forwards to the normal
position
11
Incomplete sealing or
cutting, or the sealing
line is broken
Sealing time is short Increase the sealing time by
0.1 second until the proper
sealing time is achieved
The upper sealing blade and the
sealing base do not completely
contact each other Adjust the sealing blade
position
Tefl on tape is damaged Change the Tefl on tape
The silicon bar of the sealing
base is damaged Replace the silicon bar
The protective plates are not
completely contacted Adjust the protective plates
Too much fi lm residue is
sticking on the sealing wire Clear the fi lm residue and
lower dwell time
12
The waste fi lm
conveying does not
stop
optical sensors are out of
alignment Align the optical sensors
until the sensor light is ON
Optical sensor is not
functioning Change the optical sensor
13 Product pressed by the
side sealing blade Product does not convey on the
guiding side Put the product correctly
on the guiding side of the
conveyor
14 Product pressed by the
front sealing blade The Conveying time of extra
fi lm at the rear is too short
and the product does not
completely pass through the
sealing blade unit Increase the conveying
time of extra fi lm at the
rear side of the product
The packing product is
transparent or has an irregular
shape Try to use the point to point
compensation sensor mode