SEAL AquaSEAL SW-2600, Руководство по эксплуатации для владельца

Страница: 32 / 44

5.7 Webbing the Coater
ƒ
The webbing process will require approximately 6-8ft (2.7m) of leader
material.
Locking Pin
ƒ
Ensure that the coater is in PRE-HEAT Mode.
ƒ
Load a blank tube onto the Take-Up Roller by removing the
Locking Pin, lifting the roller and sliding the tube into position
(the position of the blank tube from each end of the Take-Up
Roller needs to be the
same as the loaded substrate on the
Unwind Roller).
ƒ
After loading the tube return the roller to its cradle and replace
the Locking Pin.
ƒ
Pull substrate over the top of the Web Idler Roller and under the Draw-
Down Applicator (see Figure 19). Ensure that the substrate edge is being
webbed straight and perpendicular to the Web Idler Roller directly above
the Unwind Roller.
Figure 18:
Take-Up Roller
ƒ
Tighten the Tension Control Knob (clockwise) to add a small amount of
tension to the Unwind Roller - may make webbing the coater easier.
ƒ
Pull the substrate under the Dryer Panel to the Take-Up Roller.
ƒ
From the back of the machine, pull the substrate square and then tape the
edge securely to the blank tub on the Take-Up Roller. Make sure that the
material is not wrinkled or misaligned.
ƒ
It is important to get the material as straight as possible and square to the
rollers, to ensure a minimal amount of “telescoping” on the Take-Up Roller.
22