Seagull Models ISPORTS 10cc, Инструкция по сборке

Страница: 15 / 31

WWW.SEAGULLMODELS.COM
15
COWLING.
1) Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl
with the marks you made on the fuselage
then trim and cut as shown.
Cut.
Cut.
2) While keeping the back edge of the
cowl flush with the marks, align the front
of the cowl with the crankshaft of the
engine. The front of the cowl should be
positioned so the crankshaft is in near-
ly the middle of the cowl opening. Use
the spinner backplate as a guide. Hold
the cowl firmly in place using pieces of
masking tape.
Because of the size of the cowl, it may be nec-
essary to use a needle valve extension for the
high speed needle valve. Make this out of suf-
ficient length 1.5mm wire and install it into
the end of the needle valve. Secure the wire in
place by tightening the set screw in the side of
the needle valve.