Seagate Technology IronWolf ST6000VN001, Руководство по эксплуатации продукта

Страница: 14 / 35

Seagate IronWolf Product Manual, Rev. A 13
www.seagate.com Drive Specifications
2.7.3 Voltage tolerance
Voltage tolerance (including noise):
• 5V ±5%
• 12V ±10%
2.7.4 Power-management modes
The drive provides programmable power management to provide greater energy efficiency. In most systems, users can
control power management through the system setup program. The drive features the following power-management
modes::
• Active mode
The drive is in Active mode during the read/write and seek operations.
• Idle mode
The electronics remain powered, and the drive accepts all commands and returns to Active mode when disk access
is necessary.
• Standby mode
The drive enters Standby mode immediately when the host sends a Standby Immediate command. If the host has
set the standby timer, the drive enters Standby mode automatically after the drive has been inactive for a specifi-
able length of time. The standby timer delay is established using a Standby or Idle command. In Standby mode, the
electronics are in low power mode, the heads are parked and the spindle is at rest. The drive accepts all commands
and returns to Active mode when disk access is necessary.
• Sleep mode
The drive enters Sleep mode after receiving a Sleep command from the host. In Sleep mode, the electronics are in
low power mode, the heads are parked and the spindle is at rest. The drive leaves Sleep mode after it receives a Hard
Reset or Soft Reset from the host. After receiving a reset, the drive exits Sleep mode and enters Standby mode.
• Idle and Standby timers
Each time the drive performs an Active function (read, write or seek), the standby timer is reinitialized and begins
counting down from its specified delay times to zero. If the standby timer reaches zero before any drive activity is
required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all com-
mands and returns to Active mode when disk access is necessary.
Power modes Heads Spindle Electronics
Active Tracking Rotating Full Power
Idle, Performance Tracking Rotating Full Power
Idle, Active Floating Rotating Partial Power
Idle, Low Power Parked Rotating Partial Power
Standby Parked Stopped Low Power
Sleep Parked Stopped Low Power