Seaga JDL-2 COMBO, Руководство по обслуживанию и запасным частям

Страница: 4 / 78

4 JDL V1.0 8 2022
SPECIFICATIONS
The vending machine is comprised of two(2) units - Snack Unit (JDLS) and Beverage Unit (JDLD). Installation
and setup of these units is explained in the next sections of this manual.
Machine Description Snack Unit Beverage Unit
Model Number JDL2S
(115VAC)
JDL2S
(230VAC)
JDL2B
(115VAC)
JDL2B
(230VAC)
Height (in)
28.5” (72.4 cm) 28.5” (72.4 cm) 41.6” (105.7 cm) 41.6” (105.7 cm)
Width (in) 30.2” (76.7 cm) 30.2” (76.7 cm) 30.2” (76.7 cm) 30.2” (76.7 cm)
Depth (in)
28.6” (73 cm) 28.6” (73 cm) 28.6” (73 cm) 28.6” (73 cm)
Volts (V) 115 V 230 V 115 V 230 V
Frequency (Hz)
60 Hz 50 Hz 60 Hz 50 Hz
Watts (W) 46 W 49 W 295 W 290 W
Current (A)*
0.4 A 0.22 A 3.6 A 1.87 A
Refrigerant Type NA NA R290 R134a
Refrigerant Charge
NA NA 45 grams/1.59 oz 200 grams/7.05 oz
* - Current draw varies depending on Operating Conditions and Load and are subject to change.
The vending machine is designed for use in indoor conditions only. The recommended operating
environment is 75° F and 40% RH.
CAUTIONS
Your vender is intended for indoor use only.
Excessive heat, cold or humidity levels will void your warranty; install only in climate
controlled, indoor environments. For indoor machines the temperature range must be no
higher than 32°C/90°F and no lower than 10°C/50°F with a relative humidity (Rh) level of no
greater than 40%.
Your vender must be set on a level, well-supported location.
Always remove products before transporting it.
CAUTION!
It is important that this machine is hooked up to the proper voltage. Verify the voltage before
connecting the machine to a wall outlet.
CAUTION!
Different countries may have different power arrangements. Ensure that the machine is
properly grounded before operating.