4–TEC SC Models
SET-UP
Install the battery vent tube.
WARNING
Ensure vent tube is not kinked or obstructed.
Battery vent tube must be properly installed.
Venturi
1
F08A076
Secure the lower portion of the venturi [[[[1]]]] with:
- 2 hexagonal bolts from section no. 1 of
predelivery kit.
- 2 lock washers from section no. 1 of predelivery
kit.
- Two 8 mm flat washers (previously removed).
Torque to 21
N•m (
15
lbf•ft)
.
Access Door
1
F02L3X7
Open the front storage compartment cover.
Remove the storage tray.
Secure the access door [[[[1]]]] with:
- 7 plastic darts from section no. 2 of predelivery
kit.
- 4 plastic darts are already in place.
FINAL PREPARATION
Steering Alignment
N
N
N
NO
O
O
OT
T
T
TE
E
E
E::::
All adjustments have already been
performed at the factory. If readjustments is
needed, the following procedures should be used.
Check steering alignment as per procedure in the
appropriate
Sea-Doo Shop Manual
.
Predelivery
2004-1
5 / 15
