SD-EN-020
V01
G24-HDMI Quick Start Manual
Note
1.
Do not fix the device to any surface which is a heat source to avoid over heating
2.
Do not cover the surface or ventilation grills of the device to avoid over heating
1.
Verify the package contents
Please verify the package contents against the List Below
1.
G24-HDMI Controller
x1
6.
USB to RS232 Cable
x1
2.
12V/3A Power Adapter
x1
7.
RS232 to Phoenix Cable
x1
3.
Quick Start Manual
x1
8.
5-pin Phoenix Connector
X1
4.
Network Cable
x1
9.
3-pin Phoenix Connector
X1
5.
Mounting Ear
X2
10.
Download Guide Card
X1
2.
Set up the G24-HDMI
I.
Connect the power cable to the unit and power it up
II.
Connect the outputs to the screens of the video wall
III.
Connect all the video sources to the inputs of the devices
Note:
G24H remembers the settings used on the device before powering off. The default setting for the new
unit is
2x2
video wall with
input 1
across the 4 screens. All outputs are set at resolution of 1920 x 1080@60.
3.
Run the software on control PC
Users can run the G24.exe software directly without installation. Software can be downloaded from the SEADA
website (
). Double click the G24 software to get started.
4.
Connect through Serial Port
Connect the G24-HDMI with a serial cable to the control PC (cable not included in the package)
If the software was connected via UART (RS232) last time,
software will connect to the G24-HDMI automatically via
RS232. If it was used at Network last time, a ‘Network
Timeout’ error message will be shown on screen and users need to set up as below for RS232 connection in
the software
•
Choose ‘
UART
’ instead of ‘
Network
’
•
Select the
COM port
from the
Port
dropdown menu
•
Press
‘Disconnected’
button to connect
5.
Connect through Network
The default IP address for G24-HDMI controller is
192.168.0.247,
Users need to change the IP address of the
control PC to
static
IP address and the same network segment as the G24-HDMI at
TCP/IPv4
in
Ethernet
Properties
IP address: any address between
192.168.0.2
and
192.168.0.254
except the address which has been taken
by the G44-HDMI
Subnet mask:
255.255.255.0,
Default Gateway:
192.168.0.1
Connect the G24-HDMI with a CAT cable to the control PC (cable included in the package)
