950-0289revB - 18 - July 22, 2022
Figure 17
Electrical connection of the indoor unit (Wall-mounted)
Open the front cover by pressing inward on the sides of the cover near the bottom to release, then pull bottom
of cover outwards.
Feed the cable wire in from the rear of unit.
Open the electric box cover; connect the wires to the terminal strip individually according to the wiring diagram
above. Ensure that the colors of the wires and terminal No. are the same as the wiring diagram. Tighten
terminal screws for safe connections.
DO NOT CROSS WIRES
DO NOT CONNECT CONDENSATE PUMP TO THE INDOOR UNIT
After wiring, replace the electric box cover, and then close the front panel by pressing the corners inward to
latch.
Note
：
For detailed information about other types of indoor units, please refer to the manual packed with each
indoor unit.
Screws
Connecting Cable
Front Panel
Terminal Board
Electric Box
Cover
Cable to be fed
from rear of unit
Figure 16
Will vary by Model.
Identify each end of the interconnect cable and each of the
conductor using the labels provided. Units A, B, C, D and E.
