Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
®
English
51
MAINTENANCE
Considering the number of working cycles and the kind of gate, if the gate has changed the clutches and doesn’t
work it’s necessary to periodically proceed, with
the learning times reprogramming on the electronic control
unit.
Periodically clean the optical systems of the photocells.
REPLACEMENTS
Any request for spare parts must be sent to:
SEA S.p.A. - Zona Ind.le, 64020 S.ATTO - Teramo - Italia
SAFETY AND ENVIRONMENTAL COMPATIBILITY
Disposal of the packaging materials of products and/or circuits should take place in an approved disposal facility.
REGULAR PRODUCT DISPOSAL (electric and electronic waste)
(It’s applicable in EU countries and in those ones provided with a differential waste collection)
The brand that you find on the product or on documentation signals that the product must not be disposed off
together with other domestic waste at the end of life cycle. In order to avoid any possible environmental or health
damage caused by irregular waste disposal, we recommand to separate this product from other forms of waste and
to recycle it in a responsible way in order to provide the sustainable re-use of material resources. Domestic users
are invited to contact the retailer where the product has been purchased or the local office in charge of all the
information related to differential watse collection and recycling of this kind of product.
STORING
Materials handling must be made with appropriate vehicles..
WARRANTY LIMITS
For the guarantee see the sales conditions on the official SEA price list.
SEA reserves the right to make any required modification or change to the products and/or to this manual without
any advanced notice obligation.
Page for both installer and user
WAREHOUSING TEMPERATURES
T
min
T
Max
Dampness
min
Dampness
Max
5%
Not condensing
90%
Not condensing
- 20°C
+ 65°C
Advices
Make sure all Safeties are turned ON
Problem Found
Possible Cause
Solutions
FAILURE 24VAUX
a) Overload or short-circuit on the output N°10
b) Burnt fuse
a) Check a short circuit on the cable
b) Change fuse
Control board powers up, but
motor does not run
a) Stop button active or jumper not in place for
stop circuit
b) Open or Close Input active
c) Entrapment Protection Device active
d) Defective control board
a) Check Stop button is not "stuck on"", or verify that the stop
button is a normally closed circuit, or put a jumper on the stop
circuit
b) Check all Open and Close Inputs for a "stuck on" Input
c) Check all Entrapment Protection Device inputs for a "stuck
on" sensor
d) Replace defective control board
Solar operator not getting
enough cycles per day
a) Insufficient panel wattage
b) Excessive accessory power draw
c) Old batteries
d) Solar panels are not getting enough sunlight
a) Add more solar panels
b) Reduce the accessory power by using low power accessories
or set the 24Vaux only in cycle
c) Replace batteries
d) Relocate the solar panels away from obstructions (trees,
buildings, etc.)
Solar operator insufficient
stand-by time
a) Insufficient panel wattage
b) Excessive accessory power draw
c) Battery capacity too low
a) Add more solar panels
b) Reduce the accessory power draw by using low power
accessories
c) Use batteries with higher amp hour (Ah) rating
