Sea-Fire FD 1001-1500, Руководство по установке

Страница: 16 / 44

PN: 123-194, Rev. F Page 16 of 44
e. Pull on the cylinder (S-hook) end of the cable to retract the handle into the
Ferrule. It may be necessary to softly push on the T-handle at the same time
to seat the O-ring. Align the cross holes in the T-Handle and Ferrule and insert
the safety pin through both items so that the end of the safety pin shows out
the far side of the Ferrule.
CAUTION:
THE SAFETY PIN MUST BE THROUGH THE RED T-HANDLE AND NOT THE CABLE END-
INNER, REFERENCE FIGURE 4-C.
Figure 4-C
Leave the safety pin inserted through the T-handle/Ferrule, but do not install the
red safety seal at this time.
f.
Turn the T-handle/Ferrule so that the word FIRE is vertical or oriented as
needed.
a. This action will result in the entire cable rotating along its length. Ensure that
the cable is allowed to rotate and remain in a natural state.
g. Tighten the jam nut behind the instrument panel to lock in the position and
orientation of the T-handle/Ferrule.
Step 4 Securing cable in place
a.
Secure the cable along its length.
i. Nylon cable ties should be used for cable securing. Fasten and support the cable
on straight runs only. Do not secure at locations where cable bends.
ii. At the cylinder/actuator S-Hook end:
a. The cable should have a minimum straight length of 6 inches (15 cm) before
making any bends. The cable should be secured on a straight run before
making a bend.
b. The cable should be secured within 6 inches to 18 inches (15 cm – 46 cm) of
the cylinder. Some flexibility will be needed to move the cable for servicing
the cylinder.