PN: 123-194, Rev. F
Page 15 of 44
a.
Using the manual discharge faceplate (Figure 3) as a template, mark and drill a
13/32inch (10.4 mm) hole.
b.
Remove the protective backing from the faceplate. While aligning the holes, place
even pressure upon the faceplate. To insure a good bond, the temperature should
be in excess of 50°F (10°C).
c.
Following the diagram in Figure 4-A, install the jam nut and lock washer on the
cable end – outer. Screw the jam nut to the end of the threads. Insert the cable
end through the instrument panel and faceplate hole. Install ferrule by screwing
onto the cable end – outer until it bottoms out. Use pliers to hold the cable end –
outer while turning the Ferrule. Use pliers with rubber tips or other non-
scratching grip on the Ferrule. The safety pin can also be used to turn the ferrule.
Do not over tighten.
Figure 4-A
d.
Pull cable end – inner (threaded shaft) out to its fullest travel, and slide the rubber
O-ring over threads on shaft. Hold the cable end-inner from rotating using the
safety pin in cross hole (see Figure 4-B) or by using needle nose pliers. Install the
T- Handle on the cable end – inner, screwing it on until it bottoms out. Do not
over tighten. Remove the safety pin from the cable end-inner.
Figure 4-B
Содержание FD 1001-1500
