Sea-Fire FD 1001-1500, Руководство по установке

Страница: 14 / 44

PN: 123-194, Rev. F Page 14 of 44
a. Manual discharge release pull stations should never be installed in the protected
compartment.
b. Locate discharge pull handle at the helm station with full view and easy access by
the operator.
c. The area selected must be structurally secure and provide at least twelve (12)
inches (305 mm) of clearance at the rear of the panel to facilitate cable hardware.
Step 2 Installing cable along routing between cable ends-
a. Do not install cable in area where the possibility of physical abuse is likely. Where
practical, follow the same cable path as installed by boat manufacturer (if a
replacement cable).
b. Route the cable to allow it to lie in its most natural state. The cumulative bends in
the cable run and minimum bend radius must adhere to the following table
depending on cable series installed:
Cable
Series
Maximum
Cumulative bends (°)
Maximum No. of 90°
bends
Minimum Bend
Radius
135-X## 360 4 12 in (305 mm)
136-X## 720 8 5 in (127mm)
c. Use extreme care when bending cable to avoid kinking. Selection of the correct
size Sea-Fire cable length will reduce excess cable coil.
d. Position the cable in its routing, but do not secure at this time. Steps 3A thru 3F
must be completed prior to securing cable in its final location.

Do not connect cable to the cylinder at this time.
Step 3 Mounting cable faceplate and release (T) handle.
Confirm faceplate supplied with cable and/or cylinder assembly. The faceplate heading
should be “MANUAL/AUTOMATIC” (Figure 3).
Figure 3
Manual/Automatic systems
use faceplate 124-026