Section 08
COOLING SYSTEM
Subsection 02
(CIRCUIT, COMPONENTS AND CARE)
SMR2002-080_08_02A.FM
08-02-17
COOLANT PUMP HOUSING
1. Coolant pump housing
Removal
Drain cooling system and engine oil, refer to LU-
BRICATION SYSTEM.
Remove from housing:
– ride plate inlet and outlet hoses
– cylinder head outlet hose
no. 1
– oil cooler inlet hose
no. 2
– oil cooler outlet hose
no. 3
– screws
no. 4
and
no. 5
retaining coolant pump
housing
no. 6
– coolant pump housing
no. 6.
Inspection
Check if gasket
no. 7
is brittle, hard or damaged
and replace as necessary.
1. Weep hole pump housing gasket
Check if thermostat is in good condition. Refer to
THERMOSTAT elsewhere in this section.
Installation
The installation is the opposite of the removal pro-
cedure. Install screws as per the following illustra-
tion.
1. Screw M6 x 25
2. Screw M6 x 105
CAUTION:
To prevent leaking, take care that
the gaskets are exactly in groove when you re-
install the coolant pump housing.
Apply Loctite 243 on screw threads and torque to
10 N•m (88 lbf•
in
).
Tightening sequence for screws on coolant pump
housing is as per following illustration.
1
F18E0YA
1
F18E11A
1
2
F18E10A
1
1
1
1
2
1
F18E10B
3
2
4
5
1
88
7
6
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
