Section 08
COOLING SYSTEM
Subsection 02
(CIRCUIT, COMPONENTS AND CARE)
08-02-8
SMR2002-080_08_02A.FM
The lower hose of the valve is the water supply
and the upper hose is the regulated injection water
for the tuned pipe.
1. Water from engine water supply hose
2. Regulated injection water to the tuned pipe
3. Muffler
Regulated water is injected in the tuned pipe by a
calibrated fitting.
1. Injection fitting
COMPONENTS
Clamp
To cut or secure non-reusable Oetiker clamps of
cooling system hoses, use pliers (P/N 295 000 070).
1. Cutting clamp
2. Securing clamp
Elbow Fitting
Water injection used on exhaust system cools the
exhaust gases to obtain maximum performance
from the tuned pipe. The elbow fitting
no. 1
has a
calibrated inside diameter to optimize water flow
in tuned pipe.
The water injection also helps in reducing noise
level and cools components of the exhaust sys-
tem.
CAUTION:
The elbow fittings are calibrated and
can not be interchanged with one of a different
size as severe engine damage could result.
F06E0CA
2
1
3
1
F06E0AA
1
F01B2KA
2
www.SeaDooManuals.net
Содержание GTX 4-TEC 5573 2002
