Sea-Bird Scientific SUNA V2, Руководство пользователя

Страница: 11 / 54

• To select a specific part of the data to zoom in on, pull the mouse pointer
diagonally.
• Push Auto Range to see the data for each selected parameter. The software
adjusts the scale so that the data will always show.
• Push Default Ranges to go back to the manufacturer-set default scale for each
parameter.
• Put a check in the box next to "Show Data Points" to see the value of the
collected data when the mouse moves over each point.
• Push Select Sensors To Display to change the parameters to look at in the
Time Series graph.
5. Let the sensor or sensors collect data for approximately 5 minutes.
3.4.1 Monitor data in spectra graph
The Spectra graph shows both the dark and light data in raw counts.
The dark counts are from thermal noise. The light counts are the measured output minus
the dark counts.
The measured spectrum is always flat below 200 nm, and then has four or five peaks.
The peaks are approximately 25 nm apart in the lower wavelength range and up to 50 nm
apart in the upper range.
3.4.2 Monitor data in time series graph
The Time Series graph shows the nitrate concentration and any selected optional values.
Use this graph to replay data that is stored in the sensor.
Set up sensor and verify operation
9