E-16
Mounting the camera in the Housing
9
Put the camera's eyelets in the
positions shown by the arrows
Align the quick lock with the LOCK position to fix the camera
in place
7
8
Rotate the power switch on the housing so that it is facing the
same way as the power switch on the camera
=
Make sure that the O-ring is properly fitted in the O-ring groove before
setting of the rear case.
11
Close the locking latches
10
Set the rear case in alignment
with the guide pins (right and
left) on the front case
See:
“Opening and Closing the Housing” (P.E-9)
Pop up the camera's built-in flash.
Align the quick shoe with the
quick shoe base, and slide the
camera fully forward into the
front case
=
To make sure that the gear attached
to the lens and the gear on the front
case do not hit each other, rotate the
focus / zoom dial while sliding the
camera into place.
6
