Operation & Maintenance Manual
──
LG936 Wheel Loader
20
rained. Step on the brake pedal gently and alternately to let the skid device dry.
z
The clay piled on the ground or near the canal is soft.
Never
turn over caused by the weight of loader.
z
Never
drive the machine near hanging things or deep
ravine. These places may sink caused by the machine
weight or vibration so that the machine may overturn
and the people may be hurt or even dead.
z
Assemble anti-fall or anti-turn operator cab when
there may stone falls or the machine may turn over at dangerous working place.
z
Be careful when work continuously at rainy weather. Take care when the ground piled with
materials after earthquake or explosion.
z
Drive at low speed, prevent starting, braking or turning suddenly, use tyre chain on snowy road.
Brake alternately. Low the bucket to the ground to brake if necessary.
z
The load should be smaller when driving on snowy ground to prevent slip.
z
Take care when shovel snow because the road shoulder or other things can not be seen under the
snow.
5.8 Safety Drive on the Ramp
z
Pay attention to danger of turn over or slip when driving on the abrupt sidehill, dyke or ramp.
z
The bucket should near the ground about 200~300mm higher than the ground when driving on
the abrupt sidehill, dyke or ramp. Low the bucket to the ground to help brake or prevent turn over
under emergency cases.
z
Do not turn on ramp. Do not drive crossing the ramp
or change direction which may induce turn over.
z
Never
turn on ramp until go to the plain ground.
Slow the speed and use small turning angle when
working on abrupt sidehill, dyke or ramp.
z
Go up and down the ramp if possible, try not drive through alleyway or footway.
z
Choose proper gearshift before go down slopes and
never
shift the speed during going down
slopes.
z
Do not brake on ramp because the center of gravity is on the front tire or rear tire.
z
Use speed I when driving on ramp with full load. Go forward when drive upward the ramp, go
Содержание LG936
Страница 120: ...110 Figure5 7 Electric System Theory Using YC6108G and TD226B Engine Machinery Control...
Страница 121: ...111 Figure5 8 Electric System Theory Using Weifang TD226B Engine Pilot Control Combined Switch...
Страница 122: ...112 Figure5 9 Electric System Theory Using Dongfeng CUMMINS 6BT5 9 Engine Pilot Control Combined Switch...