SDKELI KS06 AOPD Series, Руководство по эксплуатации

Страница: 50 / 64

- 46 -
WARNING
Wiring when the power of KS06 is turned OFF
Double or reinforced insulation must be applied between the input/output interface and dangerous
voltage, otherwise may lead to electric shock.
The two OSSDs must be used together; otherwise it may reduce the safety of the system.
Properly perform the wiring after confirming the signal names of all the terminals.
Be sure to route the KS06 cable separate from high-potential power lines or through an exclusive
conduit.
Be sure to follow the relevant electrical codes, regulations, rules, and laws of the country or region
where the product is used when wiring electrical wiring.
Hot plugging for the connectors of KS06 is forbidden!
CAUTION
Safety distance and relative altitude height of every protective area must be set according to2.1.1
and2.1.2 strictly.
The main light curtain is placed forefront of the subsidiary light curtains, and then place the subsidiary
light curtains in proper order. Subsidiary light curtain1 is connected with the main light curtain directly.
The end with indicators of the subsidiary light curtain is connected with the next subsidiary light
curtain or the controller.
The serial No. of the emitter and receiver of the subsidiary light curtain must be corresponded
strictly.
The AOPD can be installed of“serial setting”,“L-type setting”and“U-type setting”or be installed with
no relevance.
Installation of KS06 cascaded AOPD：
2.3 Wiring
2.3.1 Matters needing attention
Note
：
the last subsidiary light curtain of the KS06G cascaded safety light curtain is connected to control
system of machine
.