SCULPFUN S10, Руководство по сборке

Страница: 5 / 30

Step 3 Install the belt
Installation steps:
Install the belt to the position shown in the figure, note:
1. The belt should be installed in the direction of the arrow in the figure
above.
2. The tooth pattern of the belt faces downwards and engages with the
gears.
3. Please pass the belt through the flat hole, there should be an extra part
of the belt at one end for easy pulling and tightening of the belt.
We suggest you don't cut off the extra belt after Step 4 , this is good for
the future maintenance.
Pass the belt through
the flat hole