Cobra Sport Harness Manual
The Cobra Sport Harness
Includes: 3x D-ring standard
5x 3-bar slide
2x Cobra buckle aluminum
1x stainless steel buckle
Cranked 2x D-rings
2x 1.80m Harness Soft
2x Soft Harness with sewn-in D-ring
1. Thread the long strap through the upper slots of the backplate, make sure that the
perforated side of the harness together fit on the rear side of the perforated backplate.
Now set the 3-bar slide a on the right and left side of the belt and put the stepped wire
D-ring on it.
At the end of the two straps you put the female parts of the aluminum buckles on (Make sure
that the engraving to them shows) and thread the strap back through the upper 3-bar slide.
2 Now thread the straps with sewn-in D-rings by the time piece of the Cobra
buckle. The engraving has to show it to you again.
Next, thread the second eyelets webbing through the lower slots in the backplate.
Again, the loop on the rear side of the backplate must be running before the slot in the
backplate. So the strap slides from the rear through the outer slots on the backplate.
