Remote control programming
The receiver of the remote control must be programmed during installation in order to be con-
nected to the signals from the transmitter.
The receiver is equipped with a programming procedure to automatically recognise the trans-
mitter (self-learning); this is simply achieved by pressing the button on the receiver.
Receiver programming procedure
Press the ‘P1’ button located on the receiver and the respective L.E.D. will flash 5 times.
During this flashing period, press one of the transmitter buttons to memorise the position.
The L.E.D. on the receiver will now continuously flash for 3 seconds to confirm positive record
of setting.
To set channel ‘P2’, on the receiver repeat the above operation, using the other button loca-
ted on the transmitter.
Electric connection to the blind
Connect the two-core cable with the attached ring connectors to the terminals located in the
top right corner key (top left on request), using the 2 No. screws provided. For this procedu-
re, please see the picture sequence present on the assembly instructions (H1 & H2).
During this operation please ensure that the screws are fully tightened to avoid bad connec-
tion and subsequent malfunction.
Cover the area around the connection with more secondary sealant to ensure no possibility of
water penetration creating a short circuit after glazing.
Ensure that there is no possibility of the wires being damage by the framing system causing a
short circuit.
Function of the blind
The system SL27M pleated must be connected to a power supply sufficient to ensure a con-
stant 24V dc supply to all the connected motors.
The electronic card, contained inside the blind, controls the several functions, one of which
controls the stop position corresponding to the end stop of the top and bottom positions.
The dedicated software provides two speeds. Slow speed to stop the motor slowly as the blind
approaches the end stops, and a higher speed for the raising and lowering function.
The blind function (Up / Down) is activated by switching the power supply (inversion).
It is possible to control the Up / Down inversion using a rocker switch (two way retractable –
centre off), or by a double commutator switch, or alternatively by remote radio control.
•
Using a double commutator switch (i.e. Vimar – Idea serie – code 16145), it is possible to
connect all the blinds to be controlled simultaneously with only two wires.
•
A standard rocker type switch should be used in conjunction with a dedicated “control
unit”. This system will allow any group of up to 4 blinds to be controlled together using
only two wires.
diagrams electric
17
SL27M plissé_GB 15-05-2007 9:29 Pagina 17
