SCOV SV600 Series, Руководство пользователя, Страница: 110 / 198

7 Parameter Description SV600 Series User Manual
104
Group P5: Output Terminals
SV600 series inverer provide analog output (AO) terminal, digital output (DO) terminal, relay
terminal and HDO terminal (used for high-speed pulse output or open-collector switch signal
output) for choose.
Function
code
Name Setting range Default Property
P5-00 HDO output mode selection
0: Pulse output (HDOP)
1: Switch signal output (HDOR)
0
☆
The HDO terminal is programmable multiplexing terminal. It can be used for high-speed pulse
output (HDOP), with maximum frequency of 50 kHz. Refer to P5-06 for relevant functions of
HDOP. It can also be used as open collector switch signal output (HDOR).
Function
code
Name Setting range Default Property
P5-01
HDOR output function
selection
0: No output
1: Frequency inverter running
2: Fault output (freely stop fault)
3: Frequency level detection FDT1
output
4: Frequency reached
5: Zero speed running (no output at
STOP)
6: Motor overload pre-warning
7: Frequency inverter overload
pre-warning
8: Set count value reached
9: Count value reached
10: Length reached
11: PLC cycle complete
12: Accumulative running time arrived
13: Frequency limited
14: Torque limited
15: Run Ready
16: AI1 > AI2
17: Upper limit frequency reached
18: Low limit frequency reached (No
output at stop)
19: Undervoltage status output
20: Communication setting
0
☆
P5-02
Control board relay function
selection
(T/A-T/B-T/C)
2
☆
P5-03 Reserved
P5-04
DO1 output function
selection
1
☆