Scout MT-700 ENT, Руководство по эксплуатации

Страница: 34 / 155

МТ-700 fleet tracking system 34
Universal ports P0..P5 MIC
Ci, not more than, nF 0,5 5,5
Li ,not more than, mH 50 10,5
Sparkproof class ia Ia
Table 8
C0, nF L0, nH Imax, mА Umax, V Sparkproof class
Out P6, P7 0,1 - 200 36 ic
SP 210 2,2 250 4 ic
USB 0.1 0.9 5
To the power lines in the ia class of sparkproof, sensors or power can be directly
connected.
To the power lines in the ia class of sparkproof, sensors or power can be connected
through the 2A fuse and a sparkproof block.

Terminal function test
During and after mounting the terminal, it is recommended to perform a function test
as following:
1. LED indication control.
1.1. Make sure that STATUS LED is constantly on, GPS is blinking once every 5 sec,
and GSM – once every 5 sec, or constantly on.
2. Control using a local Configurator (Detailed in chapter 4).
2.1. Connect the Configurator tie-in (subsection “local configuration”)
2.2.
Launch the “SCOUT Configurator” on the laptop and go to the “Internal sensors”
tab.
2.3. Check the network registration, satellites capture, power supply presence ( Figure
29 ).
The signal reception can be hindered or inconceivable in the following
locations: inside buildings (garage, metal box, hangar) or other places
where the clear sky view is obstructed, radio-emitting devices.
In order to conduct the listed tests of the vehicle, it should be put in
the open air, as far away as possible from radio-emitting devices and
FM-transmitters.