PAGE 26
6.7 NOTCHING THE TUBING
MODEL AL100U-01
SEE FIGURE 7
After adjusting to the correct angle (7) and the Stops (if desired) have been set up, clamp a piece of
tubing into the tubing clamp using the handle (6).
The slide with ball handle (4) moves tubing clamp side to side. It must be positioned so the piece of
tubing that is to be notched is moved toward the center of the grinding roller. Handle (5) moves tubing
clamp into and away from the grinding roller. By moving the tubing clamp into the grinding roller, the
tubing section can be notched.
Care must be given to ensure that the width of the notch does not exceed the width of the grinding belt.
MODEL AL100U-02
SEE FIGURE 8
After adjusting to the correct angle (7) and the Stops (if desired) have been set up, clamp a piece of
tubing into the tubing clamp using the handle (6).
The side with hand wheel (5) moves tubing clamp side to side. It must be positioned so the piece of
tubing that is to be notched is moved toward the center of the grinding roller. Hand wheel (4) moves
tubing clamp into and away from the grinding roller. By moving the tubing clamp into the grinding
roller, the tubing section can be notched.
Care must be given to ensure that the width of the notch does not exceed the width of the grinding belt.
The handle (8) can be installed and used in conjunction with the hand wheel (4).
See upper left drawing in FIGURE 3 to install handle.
6.8 DEBURRING
The top of the machine is equipped with a deburring table for deburring the notched tubing section.
There is a cover on top of the machine that must be opened to access the deburring table.
See FIGURE 11 on the next page.