ELANTRA
RIGHT
BRACKET
ACCENT
RIGHT
BRACKET
ACCENT
LEFT
BRACKET
ELANTRA
LEFT
BRACKET
HY1600
MOUNTING
PANEL
NOTES:
•
See your vehicle’s instructions for any special tools your installation might require.
•
Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting instructions.
This premium installation kit is for select 1995-UP Hyundai vehicles. Included are all the parts you need to mount your car
stereo, cassette, or CD player into your vehicle’s dash. Refer to the individual instruction in this manual to remove your
vehicle’s factory radio and assemble the kit.
CAUTION:
Disconnect your vehicle’s negative battery terminal before the installation to help prevent electrical damage. We
recommend the use of a volt/ohm meter over a test light to check wiring. A test light or grounded wire probe can cause
damage to the vehicle's computer and/or diagnostic systems. Avoid all factory airbag wiring - Airbags can accidentally
deploy causing serious injury or death.
INTRODUCTION / PRELIMINARY
IN-DASH INSTALLATION KIT FOR
SELECT 1995-UP HYUNDAI VEHICLES
HY1600
ASSEMBLING THE KIT
PARTS LIST
Parts List:
•
(1) Mounting Panel
•
(1) Elantra Spacers
•
(1) Accent Spacers
MOUNTING TABS
SHAFT MOUNT RADIOS
Using the hardware supplied with the radio, secure the radio shafts to the mounting panel
(kit) as shown on page 1.
DIN RADIOS
Remove the sections indicated below. Use side
cutters, an X-acto knife or hacksaw blade to cut the
top and bottom sections (follow the cut lines) then
simply pull outward to break off each tab.
RADIO/KIT ASSEMBLY
DIN CHASSIS CUTLINES
(BACK SIDE OF KIT).
RADIO INSTALLATION
Secure the radio mounting assembly to the dash using screws used to
secure the factory radio.
NOTE:
Rear support the radio.
This is very important to the
structural integrity of the
installation.
VARIOUS REAR SUPPORT
STRAP EXAMPLES.
USE THIS TAB
USE THIS TAB
FRONT OF KIT
LEFT SIDE
RIGHT SIDE
USE THE SHADED BRACKETS, AND INDICATED SPACERS.
ATTACH
ACCENT
SPACERS
ATTACH
ACCENT
SPACERS
1995-02 Hyundai Accent
RADIO REMOVAL:
1.
Extract (4) 10mm bolts from panel below steering column.
2.
Remove ashtray and extract (2) screws from the ashtray cavity.
3.
Open glovebox and use a panel removal tool to remove the glovebox stopper.
4.
Extract (2) screws and remove entire glove box.
5.
From behind glovebox area, unclip climate control cable.
6.
Unclip (2) climate control cables from behind steering column panel on the side of duct/fan assembly.
7.
Unsnap radio trim bezel, unplug and remove bezel.
8.
Extract (4) screws holding radio in, unplug connectors, antenna and remove radio.
INSTALLATION INSTRUCTIONS
