•
Accuracy: ±0.4°C/±0.7°F
•
NSF® Certified
•
4 second response
•
1.5 mm thin tip
•
3.5"/8.9 cm, 304 stainless steel stem
•
Waterproof (IPX7: protected from water up to 3
feet/1 meter for 30 minutes)
•
Field calibration
•
High heat
•
Max/min
•
Data-hold
•
Big digit
•
180° rotating display
•
On/off button
•
Auto-off after 10 minutes
•
Food-safe ABS plastic with BioCote®
•
Temperature guide on thermometer
•
2-way mounting: pocket clip/hook
•
Two 1.5V IEC LR44 button alkaline batteries
(included)
Note:
Remove label from display before initial use. Clean the
thermometer stem before each use.
Note:
In the following instructions, names of the control buttons
are shown in CAPS. Function information that appears on the
display is shown in BOLD CAPS.
Replace batteries when LCD becomes dim.
“---” flashes
on the display when the batteries need to be replaced.
1. Power off the unit before installing the batteries.
A malfunction may occur if the power is on when
the batteries are installed. If a malfunction
occurs, restart the device.
2. Using a small Phillips screwdriver, remove the
screw on the back by the pocket clip by turning it
counterclockwise.
Note:
Be careful to use a properly sized screwdriver as a
screwdriver too large will strip the screwtops.
3. Remove the cover completely.
4. Install two LR44 batteries with positive (+) sides
up.
5. Replace the battery cover.
Important: THE WATER RESISTANT FEATURE REQUIRES
MAINTAINING THE RUBBER GASKET EVENLY WITHIN THE
GROOVE
.
6. Fasten the screw on the back by turning it
clockwise, being careful not to over-turn.
A. On/Off
1. Press the POWER button (
) to turn the
thermometer on.
2. The PT0572 will automatically turn off after 10
minutes of inactivity.
3. Press the POWER button (
) again to turn the
thermometer off and conserve battery life.
B. Temperature Scale
To select temperature reading in Fahrenheit or Celsius:
1. Using a paperclip, press the °F/°C button on the
back to change the scale.
2. The °F or °C symbol changes on the display.
C. Display Rotation
While the PT0572 is on, press and hold the MAX/MIN
button to rotate the display orientation 180 degrees.
Note:
Pressing and holding the MAX/MIN button in the Max or Min
mode will clear the values.
FOR THIN CUTS OF MEAT AND
GENERAL PURPOSE COOKING
Model: PT0572
PT0572 WATERPROOF THIN TIP
THERMOMETER
-40 to +572°F/-40 to +300°C
BATTERY
INSTALLATION
OPERATING INSTRUCTIONS
