• Drag up or down the list of index numbers.
Note:
Samples are submitted in the order that they are selected and not in the order that they are shown
in the batch.
2. Make sure that the system is equilibrated prior to submitting the batch.
3. Click
Submit
.
If errors are shown at the top of the screen, then resolve them and click
Submit
again. Any errors in the batch
must be resolved prior to submitting the batch.
To start sample analysis, make sure that the queue is started. If the queue is not started, then navigate to the
Queue workspace and click
Start
on the menu bar.
Acquisition begins after the samples have been submitted from the Batch workspace.
Show or Hide Columns
1. In the Batch workspace, click
Manage > Select Columns.
2. Select or clear the column check boxes, as required, in the
Select Columns
dialog.
3. Click
OK
.
Add a Component Component Concentration Column
Use this procedure to add a component concentration column to the batch.
Note:
Component concentration columns added with this procedure are editable for all samples. Component
concentration columns are also added to a batch when a processing method that contains components is defined
for a sample. These component concentration columns are only editable for samples with processing methods
that contain the component.
1. In the Batch workspace, click
Manage > Add component concentration column
.
2. Type the name of the
Component
.
3. Click
OK
.
Delete a Component Concentration Column
Use this procedure to remove a component concentration column from the batch.
1. In the Batch workspace, click
Manage > Delete component concentration column
.
A list of components is shown. It contains all components added with the
Add component concentration
column
command, or when a MRM method or processing method was added to the batch.
SCIEX X500 QTOF System
System User Guide
87 / 234
RUO-IDV-05-2334-E
Operating Instructions—Software
