Schweitzer Engineering Laboratories SEL-351-5, Инструкция по эксплуатации, Страница: 479 / 706

Date Code 20070117
Instruction Manual SEL-351-5, -6, -7 Relay
SEL-351-5, -6, -7 Relay
Command Summary
R.Instruction Manual
Access Level 0
Command Access Level 0 is the initial relay access level. The relay automatically returns to Access Level 0
when a serial port time-out setting expires or after a QUIT command. The screen prompt is:
=
ACC Enter Access Level 1. If the main board password jumper is not in place, the relay prompts the user for the
Access Level 1 password in order to enter Access Level 1.
Access Level 1
Commands The Access Level 1 commands allow the user to look at settings information and not change it and
to retrieve and reset event, recorder, and metering data. The screen prompt is:
=>
2AC Enter Access Level 2. If the main board password jumper is not in place, the relay prompts for the entry of
the Access Level 2 password in order to enter Access Level 2.
BAC Enter Breaker Access Level (Access Level B). If the main board password jumper is not in place, the relay
prompts the user for the Access Level B password.
BRE Display breaker monitor data (trips, interrupted current, wear).
COM p
a
Show communications summary report (COM report) on M
IRRORED
B
ITS®
channel p (where p = A or B)
using all failure records in the channel calculations.
COM p d1
a
Show COM report for M
IRRORED
B
ITS
channel p using failures recorded on date d1 (see DAT command for
date format).
COM p d1 d2
a
Show COM report for M
IRRORED
B
ITS
channel p using failures recorded between dates d1 and d2 inclusive.
COM p m n
a
Show COM report for M
IRRORED
B
ITS
channel p using failure records m through n ( m = 1–512).
COM p n
a
Show a COM report for M
IRRORED
B
ITS
channel p using the latest n failure records ( n = 1–512, where 1 is
the most recent entry).
COM p C
a
Clears communications records for M
IRRORED
B
ITS
channel p (or both channels if p is not specified, COM
C command).
COM ... L
a
For all COM commands, L causes the specified COM report records to be listed after the summary.
DAT Show date.
DAT mm / dd / yy Enter date in this manner if global Date Format setting, DATE_F, is set to MDY.
DAT yy / mm / dd Enter date in this manner if global Date Format setting, DATE_F, is set to YMD.
EVE n Show event report n with 4 samples per cycle ( n = 1 to highest numbered event report, where 1 is the most
recent report: see HIS command). If n is omitted, ( EVE command) most recent report is displayed.
EVE n A Show event report n with analog section only.
EVE n C Show event report n in Compressed ASCII format for use with the SEL-5601 Analytic Assistant.
EVE n D Show event report n with digital section only.
EVE n L Show event report n with 16 samples per cycle (similar to EVE n S16 ).
EVE n L y Show first y cycles of event report n ( y = 1 to global setting LER).
EVE n M Show event report n with communications section only.
EVE n P Show event report n with synchrophasor-level accuracy time alignment.
EVE n R Show event report n in raw (unfiltered) format with 16 samples per cycle resolution.
EVE n S x Show event report n with x samples per cycle ( x = 4 or 16).
EVE n V Show event report n with variable scaling for analog values.
GRO Display active group number.