Operation
30
05.00 | WSG 25 | Assembly and Operating Manual | en | 389684
7 Operation
7.1 Operating software
The software needed to operate the product is already installed in
the unit.
NOTE
• To guarantee proper operation, the latest version of firmware
should always be installed in the product.
ð
The latest firmware can be obtained from the SCHUNK.
7.2 Integrated memory
The product's gripper control system has an integrated, non-
volatile data memory. This cannot be changed by the user.
The memory chip contains the following data:
• The software needed to operate the product
• Configuration data
• Documentation and software tools (can be called up via the
web interface)
7.3 The boot process
The product has a boot loader, which loads and runs the unit’s
software from the internal storage when the unit is powered up.
The indicator for the operating state will light up blue during this.
If there is an error, the indicator will light up red for 5 seconds.
After that the boot loader will automatically be restarted. This will
continue until firmware can be loaded correctly.
