SCHUNK VERO-S NSR 138, Перевод оригинального руководства по эксплуатации

Страница: 52 / 60

Cone seal
52 01.00 | NSR 138 / PKL 138 | VERO-S Robot Coupling for Pallet Handling | en |
1509378
12 Cone seal
To install the cone seal in the NRS 138, the recessed plug must first
be removed from the change interface and replaced with the
supplied cover with sealing ring.
The installation takes place according to the following installation
description and the illustrations
"Operational sequence of
installation of cone seal" and "Checking cone seal when loading
with clamping pallet"
1. Switch module in the installation space so that it remains
depressurized.
2. Unscrew the plug and tip the unit over to remove the plug from
the change interface. To do so, use the tool with a magnetic
insert.
3. Insert the cover including fitted sealing ring diagonally tilted
into the change interface and tighten, observing the tightening
torque,
} 6.1 [ / 18] .
4. Insert the compression springs.
5. Insert the mounting diagonally into the change interface and
lock it in the guide grooves.
6. Insert the thrust washer on the mounting in the correct
position, turn it until the radial lock engages.
7. Insert the sealing ring, pay attention to the installation location.
Gradations and overhang point towards the module flat surface.
8. Insert the cover plate.
9. Insert O-ring into the cover plate.
10
.
Screw in the countersunk screw, observe the tightening
torque,
}
6.1 [
/
18] .
11
. Check the proper functioning of the seal by activating the
unlocking function several times.
12
. Check the loading with the clamping pallet. The cone seal must
be immersed smoothly into the change interface and be reset
again. When closing the module, the sealing ring must rest on
the sealing point.