SCHUNK VERO-S NSE-T3 138, Сборка и руководство по эксплуатации

Страница: 37 / 60

Assembly
03.00|1152197 NSE3, NSE-T3 |en
37
Clamping pins SPA 40, SPB 40, SPC 40, SPG 40
NOTICE
Notes on clamping pins and mounting screws
The holding force of the quick-change pallet system is limited
essentially by the tightness of the screw connection which
connects the clamping pin to the pallet or the device. This is why
only screws of strength class 12.9 may be used.
Only original SCHUNK clamping pins may be used.
If the clamping pins are to be used in customer-owned devices,
the customer must provide sufficiently dimensioned threaded
holes or a sufficiently thick mounting material.
The clamping pins can be attached to the workpiece or pallet in 2
different ways. The left mounting option in the illustration
"Mounting the clamping pins" is the preferred option. With this
variant, if there is a module failure then the device or pallet can be
removed after disassembling the clamping pins. The mounting
screw is supplied for the mounting option on the right in the
illustration.
If clamping pins are used outside of SCHUNK pallets, for example
in customer-specific devices or workpieces, the outer diameter of
the part to be clamped must be large enough to completely cover
the inner support area of the quick-change pallet system and the
outer support areas of the system must be at least partially
covered.
4.4