SCHUNK VERO-S NSE-T3 138, Сборка и руководство по эксплуатации

Страница: 34 / 60

Assembly
34 03.00|1152197 NSE3, NSE-T3 |en
Cone seal KVS3 138
To install the cone seal in the NSE3, NSE-T3, the recessed plug
must first be removed from the change interface and replaced
with the supplied cover with sealing ring
The installation takes place according to the following installation
description and the illustrations
"Operational sequence of
installation of cone seal" and "Checking cone seal when loading
with clamping pallet"
1 Switch module in the installation space so that it remains
depressurized.
2 Unscrew the plug and tip over to remove it from the change
interface. To do so, use tool with magnetic insert.
3 Insert cover including fitted sealing ring diagonally tilted into
the change interface and tighten, observing the tightening
torque,
(

4.7, Page 44) .
4 Insert compression springs.
5 Insert the mounting diagonally into the change interface and
lock it in the guide grooves.
6 Insert thrust washer on the mounting in the correct position,
turn until the radial lock engages.
7 Insert sealing ring, observe installation location. Gradations
and overhand point towards the module flat surface.
8 Insert cover plate.
9 Insert O-ring into cover plate.
10 Screw in countersunk screw, observe tightening torque,
(

4.7, Page 44)
11 Check the function of the seal by activating the unlocking
function several times.
12 Check loading with clamping pallet. Cone seal must be
immersed smoothly into the change interface and be reset
again. When closing the module, the sealing ring must rest on
the sealing point.
4.3.6