SCHUNK VERO-S NSE-HT mini 88-20, Сборка и руководство по эксплуатации

Страница: 35 / 44

Troubleshooting
05.00|1411420_NSE-HT mini 88-20, NSE-HT mini 88-20-V1 |en-US 35
Troubleshooting
The clamping area does not unlock
Possible cause Remedial measures
Defective air connections Check air supply
Pressure below minimum Check operating pressure (min. 5 bar)
A component is broken (e.g. due to
overloading)
Replace the clamping module or send it to
SCHUNK for repair
Excess tensile load on clamping pins Reduce tensile load on clamping pins
The turbo connection is still pressurized Ventilate the connection
Leakage due to worn seal
Check for leaks (

6.1, Page 32) . In case of
leakage send the clamping module to SCHUNK
for repair
If the clamping area does not unlock perfectly
Possible cause Remedial measures
Pressure below minimum Check operating pressure (min. 5 bar)
Hose diameter below minimum For required hose diameters, see chapter
"Mounting and connection" (

4.3, Page 19)
The turbo connection is still pressurized Ventilate the connection
The quick-change pallet system no longer opens quietly
Possible cause Remedial measures
The clamping faces on the clamping slides
and on the clamping pin are dirty
Remove the clamping pin and clean the
clamping faces on the clamping slides and on
the clamping pin
Leakage due to worn seal Check for leaks
(

6.1, Page 32) . In case of
leakage, send the clamping module to SCHUNK
for repair.
8
8.1
8.2
8.3