SCHUNK VERO-S NSE-A3 138, Сборка и руководство по эксплуатации

Страница: 27 / 50

Assembly
02.00|1376941_NSE-A3 |en 27
No
.
Description
1 Unlocking connection <-- -->
2 Turbo connection --> <--
3 V4 torque pin
4 M10 x 10 detaching thread
5 Blow-off support internal
6 Blow-off support external
7 Mounting hole for M8 / Ø 9 f7 fitting screw
8 Fitting screw
9 Mounting monitoring system AFS3 138
10 Media transfer unit
11 Blow-off support torque pin / media transfer unit
Alternative connection option:
Side G1/8" connections which are free when the lower centering
diameter Ø 110 H6 is used. In this case, the bottom openings must
be sealed. To do so, insert the Ø 9 x 1.5 O-rings into the module
and seal the bottom direct connections against the flat bearing
surface.
Four coupling mechanisms for separate media transfer units are
integrated into modules with media transfer units. They are
actuated on the bottom of the module. O-rings are located in the
transfer units for sealing.
Clamping pins SPA 40, SPB 40, SPC 40, SPG 40
NOTICE
Notes on clamping pins and mounting screws
The holding force of the quick-change pallet system is essentially
limited by the tightness of the bolt connection which connects
the clamping pin to the pallet or the device. Only bolts of strength
class 12.9 may therefore be used for this.
Only original SCHUNK clamping pins may be used.
If the clamping pins are to be used in customer-owned devices,
the threaded holes provided by the customer must be sufficiently
dimensioned and sufficiently thick mounting material must be
used.
4.4