SCHUNK SWS 005, Сборка и руководство по эксплуатации

Страница: 116 / 137

Maintenance
116
12.00 | SWS | Assembly and Operating Manual | en | 389456
7.9.3 Change rubber bushing on the fluid feed-through module
Ø
Place the SWA in the storage rack, secure and uncouple it.
Ø
Switch off the power supply and ensure that there is no residual
energy in the system.
Ø
Remove the compressed air hose.
Ø
Disassemble the SWK from the robot and safely set the SWK
aside,
Removing the product from the robot arm [
}
90].
Replace the rubber bushing of the fluid feed-through module
Ø
Remove damaged rubber bushing (1).
Ø
Lightly lubricate the new rubber bushing (1),
Lubricants/greasing areas [ } 89].
Ø
Carefully insert the rubber bushing (1) into the bore with the
flat end up to the stop. The conical end points upwards.