Troubleshooting
20
03.00 | Clamping Device SVP-2 | Assembly and Operting Manual | en | 0289021
7 Troubleshooting
7.1 Tool shank cannot be inserted if pressure is built up
Possible cause
Corrective action
Toolholder has not fully engaged with the
engaging areas of the reduction insert.
Toolholder not placed on end stop.
Engage toolholder properly and place on end
stop.
Wrong toolholder/reduction insert angle.
Too much pressure could have been
applied to toolholder/reduction insert
causing constant deformation.
Ensure correct angle position of toolholder/
reduction insert (engaging surface must be
aligned with the segment).
TRIBOS toolholder not turned to right-
hand stop.
Turn TRIBOS toolholder to right-hand stop
