SCHUNK STM 560V Series, Сборка и руководство по эксплуатации

Страница: 64 / 72

Maintenance and care
64 04/STM-560V/en/2010-12-10/SW
11.3 Module Servicing
For maintenance work or repairs, send the complete module
along with a repair order to SCHUNK.
The regular visual inspection of all supply lines is the prerequisite
for the perfect operation of the STM.
 If supply lines are defective, put the machine out of operation
immediately.
 Replace damaged connection cables.
Check the STM every 2500 operating hours or once a year for
bearing noise:
Bearing noise Further procedure
Smooth noise (typical
bearing noise) Everything okay, STM can continue to be
operated.
Uneven grinding noise The motor is not set up correctly:
 check the evenness of the mounting
surfaces
(see chapter 7.1, page 26)
Loud and uneven noise /
motor not running
smoothly The motor is not set up correctly:

check the evenness of the mounting
surfaces
(see chapter 7.1, page 26)
or bearings defective:
 Consult your SCHUNK contact and
send the STM to SCHUNK along with a
repair order.
Table 26
Clean the STM dry at regular intervals to remove all dirt.
If the housing is soiled, please only rub it dry, e.g. with a cloth. Do
not immerse or spray.
When all maintenance work has been completed:
 Refit the safety devices provided, such as covers and safety
switches.
Visual inspection
Acoustic bearing
inspection
Cleaning