Assembly and settings, size 16 - 40
78
12.00 | SRM | Assembly and Operating Manual | en | 1346850
7.3.1.1 Base unit
1. Loosen nut (B1).
2. Apply pressurized air to air connection "A".
3. Open the exhaust air throttle valve at the air connection "B"
approx. two turns until the pinion (1) moves to the end
position "E1".
4. Turn the adjusting sleeve (B2) and set the desired end position.
IMPORTANT! Do not unscrew adjusting sleeve too far. The
product may become leaky.
5. Check the end position.
✓
To do this, ventilate air connection "A" and pressurize it
again, if necessary adjust end position.
6. Tighten nut (B1).
✓
Tightening torque: SRM 16: 11 Nm; SRM 20: 18 Nm;
SRM 25: 20 Nm; SRM 32: 35 Nm; SRM 40: 40 Nm
✓
End position "E1" is set.
7. Adjust other end position analogously.
8. Swivel repeatedly to test the setting, readjust if necessary.
