SCHUNK SRH-plus-D, Сборка и руководство по эксплуатации

Страница: 18 / 56

Assembly and settings
18 03.00 | SRH-plus-D | Assembly and Operating Manual | en | 1424337
5 Assembly and settings
5.1 Installing and connecting
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
•
Before starting any work on the product: Switch off the power
supply and secure against restarting.
•
Make sure, that no residual energy remains in the system.
CAUTION
Risk of damage to the product!
If the end position is approached too hard, the product may be
damaged.
•
As a rule, a rotary movement must take place without impact
and bouncing.
•
To do this, carry out sufficient throttle and dampening.
•
Observe specifications in the catalog data sheet.
CAUTION
Material damage due to opened exhaust air throttle valves!
If during first actuation the exhaust throttle valves are open, the
product may move in an uncontrolled manner.
•
Close the exhaust air throttle valves completely before
applying pressure.
Overview 1. Screw the product to the machine/system,
}
5.2.1 [
/
20] .
✓
Use centering sleeves from the enclosed accessory pack.
✓
Observe the tightening torque for the mounting screws.
2. Screw the attachment part to the swivel head,
}
5.2.1 [
/
20] .
3. In the main air connections "A" and "B", screw in throttle
valves and connect compressed air lines, } 5.2.2 [
/
22] .
✓
Screw locking screws into the main air connections "A" and
"B",
}
5.2.2 [
/
22] .
✓
Mount throttle valves in the air supply lines for the air
connections "a" and "b".
4. Check that all of the throttle valves are closed.
5. Screw in locking screws in open and not required air
connections where appropriate.