Function and handling
76
03.00 | ORG | Assembly and Operating Manual | en | 389246
5.6.9 Internal assembly IM_1.9
CAUTION
Damage to the gripper fingers if the operating pressure is too high.
During internal assembly in the range from d
1
=10 mm to d
1
=15
mm, or when working with an assembly finger with a width of
less than 2 mm, the operating pressure of triple jaw A must
reduced to max. 2.5 bar! If the operating pressure is not
reduced, the as-sembly fingers could be damaged or
destroyed.
WARNING
When working with gripper fingers with a longer overhang, the
operating pressure of triple jaw A must always be adjusted! This
reduced operating pressure depends on the individual version
of the gripper fingers!
The assembly fingers radially open up toward the outside
(compressed air connection (3) pressurised).
Internal assembly IM_1.9
The seal is pushed into the groove at the remaining three locations.
NOTE
The position of the assembly fingers in the step Internal assembly
IM_1.9 is not monitored!
