_________________________________________________________________________________________
schunk.com
XND.00014.002_A – 10/2018
19
4.2
Jaw range
The reliable function of the clamping device is significantly affected by the selection of the
correct jaws.
Fitting the jaws in the top groove
Please only use original screws (strength class 12.9). The fixing screws are subject to
load from the resulting lift-off force of the horizontal jaw!
The torque of the cylinder screws is 12 Nm.
The grip VS horizontal jaw must be fixed with 3 cylinder screws.
Third-party horizontal jaws must not be taller than 12 mm and must be supported at the rear.
5
Servicing, cleaning, maintenance
No special servicing is required, the spindle is protected by the carriage construction. Apply
machine oil to the carriage surfaces at regular intervals, e.g. with MOTOREX Supergliss 68 K
to ISO VG 68.
Remove the jaw at regular intervals and grease the thread with machine grease.
5.1
General cleaning / lubrication
Release stop screw (pos. 100).
Turn the spindle (pos. 40) until the movable
jaw (pos. 30) is released.
Lubricate the thread.
Oil the spindle head.
Oil the contact surfaces.
Release fixed jaw (pos. 20) if necessary and remove the
cover sheet (pos. 80).
6
Troubleshooting, eliminating faults
Vice is hard to operate
Dismantle, clean and the damaged surfaces must be carefully levelled off with a honing stone.
Cover sheet is disengaged at the fixed jaw
Release the fixed jaw and slide the sheet under the fixed jaw
Cover sheet is disengaged at the clamping jaw
Turn the clamping jaw fully against the fixed jaw so that the cover sheet runs on to the
clamping jaw.
